Develop
Ticket #2138 (closed defect: worksforme)
LXNAV V7 in 6.3.6 Android
| Reported by: | bobfletcher90 | Owned by: | max |
|---|---|---|---|
| Priority: | normal | Milestone: | XCSoar 6.3 |
| Component: | Other | Version: | 6.3 |
| Keywords: | Cc: |
Description (last modified by max) (diff)
The IOIO driver in 6.3.6 for LX/Colibri loads but does not find any data.
The diver status message says No Data. The monitor shows no NMEA data at most speeds, occasionally some garbled data appears. The testing was mostly done at the Flarm default speed of 19200 from the V7.
Changing to the generic driver at the same speed provided the normal data.
Back revving to 6.3.5 worked too.
The Anroid hardware was a Kyobo eReader.
Regards,
Bob
Change History
comment:2 follow-up: ↓ 3 Changed 11 months ago by max
I have received a V7 today from LXNav. It works well with the LX driver.
Please elaborate how you connected the V7 to the IOIO board. Which cable, which V7 connector? Is there a GPS connected on the GPS port? What are the port settings in the V7?
comment:3 in reply to: ↑ 2 Changed 11 months ago by bobfletcher90
Replying to max:
I have received a V7 today from LXNav. It works well with the LX driver.
Please elaborate how you connected the V7 to the IOIO board. Which cable, which V7 connector? Is there a GPS connected on the GPS port? What are the port settings in the V7?
Max,
Using a Flarm to drive the V7 at the default rate of 19,200. The TTL op from the V7 drives an IOIO board. It strange that the same configuration works fine in 6.3.5 but stopped working in my config in 6.3.6.
The V7 is running f/w 1.99.
What other data would you like?
Regards,
Bob
LXNav has promised to send test hardware. Waiting for it.